elem6 s.r.o.

Both units are already paired from the factory. Switch on both units at the same time. The units will connect after power on, the units will automatically ...

a) Press and hold the off/on button on the switched off baby unit until the the status LED flashes green. b) Then press and hold the off/on buttons on both...

Both units have a lithium battery built-in from the factory or can be powered by the included USB-C cable from the mains.

The range depends on the environment where the baby monitor is used. Thick walls, reinforced concrete structures or steel structures can reduce the signal a...

Yes, the NannyTone VM3 audio baby monitor has two-way communication.

The baby unit does not transmit sound when VOX mode is activated. The sound is activated only when it detects a noise. This mode increases the overall batte...

The small led lamp can be switched on by triple pressing the rear button on the baby unit or by pressing the right side button on the parent unit.

a) Parent unit 1) Unscrew the rear cover of the parent unit with a Phillips screwdriver. 2) Remove the rear cover. 3) Disconnect the old, non-functioning...